 |
| This is a picture of my first time soldering. First we used flux to remove any oxidation. After soldering and clipping the wires we used isopropyl alcohol to clean the reaming flux off the board. |
 |
| A picture of my components attached to the board. |
 |
| Next, we practiced soldering wires. First we removed the insulation off the wire then carefully put the wires side by side to solder them. Finally we added shrink tubing to properly insulate the joint. |
 |
| A picture of an ac adapter that we soldered. |
 |
| A Breadboard showcasing my ac adapter lighting up a bulb. |
No comments:
Post a Comment